B Series Truck 4WD L4-2606cc 2.6L SOHC (1992)
satisfactory, adjust anchor bolt until specified height difference is obtained.
9.
If anchor bolt was not marked during disassembly, install torsion bar spring as follows:
a. On 2WD models, install anchor arm to torsion bar spring so that there is approximately 4.92 inches between anchor arm tip and crossmember.
b. On 4WD models, install torsion bar spring so that there is approximately 1.18 inch from body bracket to tip of anchor arm.
c. On 2WD models, tighten anchor bolt until anchor arm contacts the anchor bolt swivel, then tighten anchor bolt an additional 1.77 inch.
d. On 4WD models, lower vehicle and ensure vehicle is level with relation to ground. If vehicle height is high, loosen anchor bolt. If vehicle
height is low, tighten anchor bolt.