B Series Truck 4WD L4-2606cc 2.6L SOHC (1992)
12.
Install front axle driveshaft. Do not damage oil seal. After installation, pull front axle driveshaft outward and ensure it does not disengage.
13.
Install knuckle and hub to front axle driveshaft and ball joints.
14.
Install spacer and snap ring.
15.
Install shock absorber and stabilizer.
16.
Install tie rod end, then the caliper assembly, knuckle arm, wheel and freewheel hub.
17.
Apply sealant to the drive flange and install it.
18.
Install engine undercover, torquing attaching bolts to 31-46 N.m (3.2-4.7 m-kg, 23-34 ft. lbs.
19.
Lower the vehicle.
20.
Tighten the lower mount of the shock absorber to the specified torque with the vehicle unladed.
Tightening torque: 55-80 N.m (5.6-8.2 m-kg, 41-59 ft-lb)
21.
Check the steering angle and toe-in and adjust if necessary.
Disassembly and Reassembly