CX-7 L4-2.3L Turbo (2007)
Auxiliary Step / Running Board: Service and Repair
SIDE STEP MOLDING REMOVAL/INSTALLATION
Removal
1. Remove the fastener.
2. Pull the side step molding front and remove clip A from the vehicle body.
3. Slide the side step molding front to the vehicle front and remove clip B from the side step molding front.
4. Remove the side step molding front.
5. Remove clips B from the body, then install it to the side step molding front.
6. Pull the side step molding front and remove clip C and F from the vehicle body.
7. Detach clip D using a tape-wrapped flathead screwdriver as shown in the figure.
8. Slide the side step molding to the vehicle rear and remove clips E from the side step molding.
9. Remove the side step molding.
10. Remove clips E from the body, then install it to the side step molding.
Installation
