CX-7 L4-2.3L Turbo (2007)
^
Do not push or turn the inner cable in the cable housing. The front cable may disconnect from the rear cables at the equalizer joint
underneath the vehicle.
7.
Confirm there is no damage or flaws to the cable inner wire.
NOTE:
^
Be sure the cable has no damage or breakage, and the inner wire of the cable is not exposed.
^
If the inner wire of the cable is damaged/flawed, replace it. Refer to Removal Procedure of Front Parking Brake Cable".
^
If the inner wire of the cable is not damaged/flawed, proceed to Installation Procedure of Parking Brake Pedal".
INSTALLATION PROCEDURE OF PARKING BRAKE PEDAL
1.
Install front parking brake cable to parking brake pedal assembly.
NOTE:
^
Install the front parking brake cable along the groove of the parking brake pedal assembly.
^
Insert the tip of the front parking brake cable and the square part in the hole for the front parking brake cable until the tip of the front
parking brake cable comes out of the hole.
^
Temporarily tighten the nut.
^
When installing the front parking brake cable, be sure that the cable goes under the bracket for cable on the parking brake pedal assembly.
^
Be sure that the cable has no damage or breakage, and the inner wire of the cable is not exposed.
^
Be sure that the square part is completely fitted. If not, the nut for brake stroke adjustment cannot be tightened properly.
