CX-7 L4-2.3L Turbo (2007)
1. Insert the wheel unit valve into the valve hole so that the polyurethane foam side faces the rim.
Note:
^
Maintain the wheel unit in contact with the rim, then start manually to screw the valve nut for a few turns.
2. Install the nut from the outer side of the wheel.
3. Tighten the valve nut slowly (15 rpm max.) to 8.0 Nm (82 kgf-cm, 71 in-lbf) in one rotation.
Caution
^
Do not retighten the valve nut after the initial operation.
4. Set the tire changer so that it is 45° away (point A) from the valve hole.
Caution:
^
Do not position the tire changer near the tire valve to avoid any damage to the wheel unit.