CX-7 L4-2.3L Turbo (2007)
e.
Push shock absorber and coil spring component downward, and turn identification mark to desired position.
^
IF THE VEHICLE PULLS RIGHT, ROTATE THE LEFT SIDE STRUT MOUNTING RUBBER 180 DEGREES SO THE POSITION OF
THE "IDENTIFICATION MARK" IS INSIDE THE CIRCLE.
^
IF THE VEHICLE PULLS LEFT, ROTATE THE RIGHT SIDE STRUT MOUNTING RUBBER 180 DEGREES SO THE POSITION OF
THE "IDENTIFICATION MARK" IS INSIDE THE CIRCLE.
11.
Reinstall components according to Steps a - d.
a.
Reinstall shock absorber and coil spring.
b.
Tighten mounting rubber nuts to specified torque.
Tightening Torque: 46.1 - 62.7 Nm {4.71 - 6.39 kgfm, 34.1 - 46.2 ft. lb.}
c.
Reinstall cowl grille.
d.
Reinstall windshield wiper arm.
12.
Confirm wheel alignment is within specification.
13.
Verify repair.
