mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Fuel System - MIL ON/DTC P2119 Set|Page 3852 > < Fuel - Revised Throttle Body Replacement Procedure|Page 3847
Page 1
background image

Throttle Body: All Technical Service Bulletins
Fuel System - MIL ON/DTC P2119 Set

Bulletin No: 01-024/10 
Last Issued: 04/19/2010

Subject
MIL ILLUMINATION WITH DTC P2119

APPLICABLE MODEL(S)/VINS

2007 CX-7 vehicles with VINS lower than JM3ER****7*167713 (produced before April 11, 2007)

DESCRIPTION

Some vehicles may experience MIL illumination with DTC P2119 stored in memory when the engine is started, then it shifts into Limp Home" mode and
the engine output decreases.

P2119: Throttle actuator control throttle body range/performance problem.

This may be caused by worn throttle valve internal drive gears causing friction to increase. The throttle valve may not properly return to the fully closed
position when the ignition is shut off.

As a mass-production change, additional grease has been applied to the throttle valve internal drive gears. Customers having this concern should have
their vehicle repaired using the following repair procedure.

REPAIR PROCEDURE

WARNING:

For your safety, do not begin this repair until the engine has fully cooled.

1. Verify customer concern.

2. Replace throttle body and gasket with modified parts.

a. Remove the charge air cooler.

b. Disconnect the throttle body connector.

c. Remove the throttle body with water hose connected.

Fuel System - MIL ON/DTC P2119 Set|Page 3852 > < Fuel - Revised Throttle Body Replacement Procedure|Page 3847