CX-7 L4-2.3L Turbo (2007)
Wastegate Actuator: Testing and Inspection
WASTEGATE ACTUATOR INSPECTION[L3 WITH TC]
1. Remove the air hose and air duct.
2. Disconnect the hose from the wastegate actuator.
3. Plug the wastegate actuator as shown in the figure.
4. Connect the vacuum pump to the port
5. Raise the pressure slowly and take a measurement of the pressure when the rod stroke is 1.5 mm (0.06 in).
-
If the rod does not move, replace the turbocharger.
Specification (rod stroke: 1.5 mm (0.06 in))
78.0-83.4 kPa (586-625 mmHg, 23.1-24.6 inHg)