CX-7 L4-2.3L Turbo (2007)
Transmission Speed Sensor: Testing and Inspection
INPUT/TURBINE SPEED SENSOR INSPECTION [AW6A-EL, AW6AX-EL]
On-Vehicle Inspection
Caution:
^
Water or foreign material entering the connector can cause a poor connection or corrosion. Be sure not to allow water or foreign
material on the connector when disconnecting.
^
Do not damage the terminals.
1. Disconnect the negative battery cable.
2. Remove the air cleaner component.
3. Remove the TCM.
4. Verify that there is no continuity between the coupler component terminals B12 and GND or B13 and GND.
^
If there is any malfunction, inspect the coupler component.
^
If the coupler component is normal, perform an off-vehicle inspection of input/turbine speed sensor. (See Off-Vehicle Inspection.)
Note:
^
Inspect with a tester that can indicate more than 10 megohms and confirm that the value is more than 1 megohm.
5. Verify that there is continuity between coupler component terminals 1312 and 1313.
^
If there is any malfunction, inspect the coupler component.
^
If the coupler component is normal, replace the input/turbine speed sensor.
6. Install the TCM.
7. Install the air cleaner component.
8. Connect the negative battery cable.
Off-Vehicle Inspection
Warning:
^
A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool before replacing the ATF.
Caution:
^
Water or foreign material entering the connector can cause a poor connection or corrosion. Be sure not to allow water or foreign
material on the connector when disconnecting.
^
Do not damage the terminals.
1. Disconnect the negative battery cable.
2. Remove the air cleaner component.
