CX-7 L4-2.3L Turbo (2007)
11. Remove the O-ring and the gasket from the coupler component.
12. Apply ATF to a new gasket and install it on the coupler component.
Caution:
^
Do not apply ATF to the O-ring.
13. Install a new O-ring to the coupler component.
Caution:
^
Do not apply too much force to the coupler component.
^
Do not damage the coupler component.
14. Install the coupler component to the transaxle case.
15. Install a new coupler component lock plate.
16. Install the control valve body.
17. Install the thermo valve.
18. Install the resonance chamber.
19. Install the TCM.
20. Add ATF to the specified level.
21. Install the under cover.
22. Install the air cleaner component.
23. Connect the negative battery cable.
24. Perform the mechanical system test. (See MECHANICAL SYSTEM TEST [AW6A-EL, AW6AX-EL].) See: Testing and Inspection/Initial
Inspection and Diagnostic Overview/Mechanical System Test [AW6A-EL, AW6AX-EL]
