CX-7 L4-2.3L Turbo (2007)
10. Press the activation switch on the SST (Deployment tool) to operate (deploy) the side air bag module.
11. Disconnect the SSTs (Deployment tool) from the SSTs (Adapter harness).
Curtain Air Bag Module
1. Remove the curtain air bag module.
2. Secure the curtain air bag module in a vise, and cut off the deployment section, as shown in the figure.
WARNING: Be sure not to crush the pipe on the side where it is cut. If it is crushed completely, the interior pressure of the pipe will
build up and can cause it to explode during air bag module operation (deployment).
3. Connect the SST (Adapter harness) to the curtain air bag module as shown in the figure.
4. Secure the curtain air bag module to the tire, by wrapping a wire (cross section 1.25 sq.mm {0.002 sq.in} or more) through the tire and the bolt
installation holes at least 4 times as shown in the figure.
WARNING: If the air bag module is not properly installed to the tire, serious injury may occur when the module is operated (deployed).
Make sure to install the air bag module securely.
