CX-7 L4-2.3L Turbo (2007)
c.
Locate the wire in terminal 4 of the 24-pin connector.
-
CX-7 - Black/Red
-
CX-9 - White/Black
d.
Carefully strip away 3/4" of the sheathing from the wire.
e.
Using a scratch awl tool, pierce the center of the stripped section of the wire and create an eyelet to allow for additional wires as shown.
f.
Remove the pre-stripped insulation from the Red/White wire of the load reduction relay harness and insert it through the eyelet made in the
Black/Red wire (CX-7) or White/Black wire (CX-9) of the remote start harness.