CX-7 L4-2.3L Turbo (2007)
Suspension Spring ( Coil / Leaf ): Removal and Replacement
Front Suspension
FRONT SHOCK ABSORBER AND SPRING REMOVAL/INSTALLATION
Caution:
^
Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the
harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to
an appropriate place where the sensor will not be pulled by mistake while servicing the vehicle.
1. Remove the windshield wiper arm.
2. Remove the cowl grille.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5. Inspect for front wheel alignment, and adjust it as necessary.
Front Shock Absorber and Coil Spring Installation Note
1. Install the front shock absorber and coil spring so that the identification mark on the mounting rubber is facing to the position indicated in the
figure.
