CX-7 L4-2.3L Turbo (2007)
Seals and Gaskets: Service and Repair
Oil Seal (Oil Pump) Replacement [AW6A-EL, AW6AX-EL]
OIL SEAL (OIL PUMP) REPLACEMENT [AW6A-EL, AW6AX-EL]
1. Remove the transaxle.
Caution:
^
The oil seal is easily damaged by the sharp edges of the torque converter splines. Do not let the splines contact the oil seal.
^
Do not drop the torque converter.
^
Do not pinch fingers.
2. Remove the torque converter.
Caution:
^
Do not to damage the bushing on the oil pump body.
3. Using a tape-wrapped flathead screwdriver, remove the oil seal from the oil pump body
4. Using the SST and a hammer, install the oil seal to the oil pump body.
Substitution SST
^
49 U027 003
Outer diameter: 67 mm (2.64 in) or more
Inner diameter: 54 - 61 mm (2.13 - 2.40 in)
Plate thickness: 2 mm (0.08 in) or more
5. Coat the lip of the oil seal with grease.
6. Install the torque converter.
7. Install the transaxle.
8. Perform the mechanical system test. (See MECHANICAL SYSTEM TEST [AW6A-EL, AW6AX-EL].) See: Transmission Control
Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Mechanical System Test [AW6A-EL, AW6AX-EL]
