CX-7 L4-2.3L Turbo (2007)
9. Disconnect the solenoid connectors, VSS connector and the input/turbine speed sensor connector.
10. Disconnect the coupler component from the clamp.
11. Remove the lock plate, and pull out the TFT sensor from the control valve body.
12. Remove the O-ring from the TFT sensor.
Note:
^
Be sure to secure the coupler component with tape so that it will not interfere with the control valve body component.
13. Fix the coupler component with tape to the transaxle case as shown in the figure.
14. Remove the VSS connector and input/turbine speed sensor connector from the solenoid clamp.
