CX-7 L4-2.3L Turbo (2007)
4. Then, select the "Transmission Learning".
5. Perform the N range learning according to the directions on the screen.
^
When "Operation Successful" is displayed, shift the selector lever to the P position and turn the ignition switch to the LOCK position, then to
the ON position after 5 s.
^
If "Reinstall TCM properly and then try again" is displayed, perform the following inspection:
-
Verify that the transaxle manual shaft is in the N position.
^
If the manual shaft is in a position other than N, shaft it to the N position.
-
Verify that the selector cable is adjusted properly.
^
If the selector cable is not adjusted properly, adjust it.
-
Inspect the manual shaft lever for deformation.
^
If there is any malfunction, replace the manual shaft lever.
6. Shift the selector lever from P position to D range, then verify that the positions of the selector lever and the indicator are aligned.
^
If there is any malfunction, inspect the DTC. (See DTC Table [AW6A-EL, AW6AX-EL].) See: Powertrain Management/Computers and
Control Systems/Testing and Inspection/Diagnostic Trouble Code Descriptions
