CX-7 L4-2.3L Turbo (2007)
3. Remove the under cover.
4. Drain the ATF.
5. Remove the resonance chamber.
6. Remove the thermo valve.
7. Remove the control valve body.
8. Remove the input/turbine speed sensor.
9. Connect the input/turbine speed sensor terminal 2 to the battery positive terminal, connect the battery negative terminal to input/turbine speed
sensor terminal 1 through an ammeter set to a resistance of 100 ohm.
10. Measure the current while waving a magnet back and forth over the top of the input/turbine speed sensor (less than 5 mm (0.197 in)). If there is
any malfunction, replace the input/ turbine speed sensor.
Input/turbine speed sensor
Input/turbine Speed Sensor
11. Install the input/turbine speed sensor.
