CX-7 L4-2.3L Turbo (2007)
Shift Solenoid: Testing and Inspection
SOLENOID VALVE INSPECTION [AW6A-EL, AW6AX-EL]
Resistance Inspection (On-Vehicle Inspection)
Caution:
^
Water or foreign material entering the connector can cause a poor connection or corrosion. Be sure not to allow water or foreign
material on the connector when disconnecting.
^
Do not damage the terminals.
1. Disconnect the negative battery cable.
2. Remove the air cleaner component.
3. Remove the TCM.
4. Measure the resistance between the following terminals.
^
If there is any malfunction, inspect the coupler component.
^
If the coupler component is normal, replace the control valve body.
Solenoid Valve Resistance
5. Install the TCM.
6. Install the air cleaner component.
7. Connect the negative battery cable.
Continuity Inspection (On-Vehicle Inspection)
Caution:
^
Water or foreign material entering the connector can cause a poor connection or corrosion. Be sure not to allow water or foreign
material on the connector when disconnecting.
^
Do not damage the terminals.
1. Disconnect the negative battery cable.
2. Remove the air cleaner component.
3. Remove the TCM.
4. Verify that there is no continuity between coupler component terminals B1, B3, B4, B9, B10, B11, B14, B17, B18, B21, B22 and GND.
^
If there is any malfunction, inspect the coupler component.
^
If the coupler component is normal, replace the control valve body.
5. Install the TCM.
6. Install the air cleaner component.
7. Connect the negative battery cable.
