CX-7 L4-2.3L Turbo (2007)
Windshield Washer Switch: Removal and Replacement
Wiper and Washer Switch
WIPER AND WASHER SWITCH REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the column cover.
3. Disconnect the wiper and washer switch connector.
4. Remove the screws, then remove the wiper and washer switch.
5. Install in the reverse order of removal.
Combination Switch
COMBINATION SWITCH REMOVAL/INSTALLATION
WARNING: If the negative battery cable or the steering angle sensor connector is disconnected, the stored initial position of the steering
angle sensor will be cleared and the DSC will not operate properly, making the vehicle unsafe to drive. Perform the steering angle sensor
initialization procedure after connecting the negative battery cable.
1. Disconnect the negative battery cable.
2. Remove the following parts:
1. Driver-side air bag module
2. Steering wheel
3. Column cover
3. Remove in the order indicated in the table.
4. Disconnect the steering angle sensor connector.
5. Install in the reverse order of removal.
6. Perform the steering angle sensor reference point setting.
