CX-9 AWD V6-3.7L (2008)
Parking Assist Control Module: Removal and Replacement
BLIND SPOT MONITORING (BSM) CONTROL MODULE REMOVAL/INSTALLATION
CAUTION: If the BSM control modules are installed with the left and right modules reversed, a DTC will be displayed and system will enter
the fail-safe function. Therefore, confirm that the left/right BSM control modules are installed correctly.
1. Disconnect the negative battery cable.
2. Remove the rear combination light.
3. Remove the rear bumper.
4. Pull the connector in the direction shown by the arrow (2) in the figure and remove it while pressing the tab in the direction shown by arrow (1).
5. Remove the nuts.
6. Remove the BSM control module.
7. Install in the reverse order of removal.
8. Perform the blind spot monitoring radar test. (See BLIND SPOT MONITORING (BSM) RADAR TEST.) See: Accessories and Optional
Equipment/Collision Avoidance and Parking Assist Systems/Testing and Inspection/Component Tests and General Diagnostics