Millenia V6-2255cc 2.3L DOHC (1995)
8. Connect the SST to the ignition timing checking harness with the arrow on the clamp facing the connector.
9. Verify that the ignition timing is within specification.
Specification: BTDC 6 - 8° (7 ± 1°)
10. If not as specified inspect following.
^
On-board diagnosis system
^
Camshaft position sensor
^
Crankshaft position sensor
11. Disconnect a jumper wire.
12. Verify that the ignition timing is within specification.
Specification: BTDC -5 - 17°
Idle Speed
1. Perform Preparation.
2. Connect a tachometer to the data link connector terminal IG-.
3. Verify that the idle speed is within specification.
Specification: 600 - 700 (650 ± 50) rpm
4. If not as specified, adjust the idle speed.
5. Connect the data link connector terminals TEN and GND by using a jumper wire.
6. Adjust the idle speed by turning the air adjusting screw.
Specification: 600 - 700 (650 ± 50) rpm
Caution: The throttle adjusting screw is set at the factory and must not be adjusted. Any adjust will negatively effect the engine performance.
