Millenia V6-2255cc 2.3L DOHC (1995)
9. If harness is OK, replace the throttle position sensor.
(Integral) Closed Throttle Position Switch
1. Verify that the throttle valve is closed throttle position.
2. Disconnect the throttle position sensor connector.
3. Loosen the attaching screws.
4. Insert a feeler gauge between the throttle adjusting screw (TAS) and the throttle lever.
Adjust the continuity between the closed throttle position switch terminals C and D by using an ohmmeter.
5. Connect the throttle position sensor connector.
6. Tighten the attaching screws.
Tightening torque:
1.6-2.3 N-m (16-24 kg-cm, 14-20 in-lb)
7. If not adjusted, replace the throttle position sensor.