Millenia V6-2255cc 2.3L DOHC (1995)
Throttle Position Sensor: Adjustments
With SST-Engine Signal Monitor
CAUTION:
-
The throttle position sensor is adjusted at the factory before shipment. Unnecessary adjustment will negatively effect the engine performance.
-
Adjusting the throttle position sensor by using the throttle adjusting screw (TAS) will negatively effect the engine performance.
ADJUSTMENT PROCEDURE
Throttle Position Sensor
Using SSTs (Engine signal monitor)
1. Remove the ECM.
2. Connect the SSTs to the ECM.
3. Verify that the throttle valve is closed throttle position.
4. Loosen the attaching screws.
5. Turn the ignition switch to ON.
6. Adjust the throttle position sensor so that the ECM terminal 3B voltage is as specified, by using a voltmeter.
Specification
Closed throttle position: 0.1-1.1 V
Wide open throttle: 2.8-4.5 V
NOTE: (Verify that the voltage increase is directly proportioned to the throttle valve opening angle.)
7. Tighten the attaching screws.
Tighten torque:
1.6-2.3 N-m (16-24 kg-cm, 14-20 in-lb)
8. If not adjusted, inspect the throttle position sensor harness.