Millenia V6-2255cc 2.3L DOHC (1995)
Fail-safe relay
1. Measure resistance between terminals c and d of ABS relay connector.
Resistance: 60-100 ohms
2. Check for continuity between terminals a and e, and between b and e.
3. Apply 12 V between terminals d and c. Check for continuity between terminals b and e and between a and e.
4. If not as specified, replace the ABS relay.
Motor relay (including harness to ABS CU)
1. Inspect the fail-safe relay.
2. Turn the ignition switch OFF and disconnect the ABS control unit connector.
3. Turn the ignition switch ON.
ABS
ABS/TCS
4. Connect terminal 2J [2B for ABS/TCS] to a ground.
5. Connect terminal 2H [2A for ABS/TCS] to a ground.
6. Check the following points:
CAUTION: Allowing the motor to operate for more than two seconds will damage the motor.