Millenia S V6-2.3L DOHC (Miller cycle) (2000)
Air/Fuel Mixture: Testing and Inspection
ENGINE TUNE-UP [KJ]
Preparation
1. Warm up the engine to normal operating temperature.
2. Shift the selector lever to P or N position.
3. Turn off all electrical loads.
^
Headlight
^
Blower motor
^
Rear window defroster
^
A/C
^
P/S
4. Wait until the cooling fan stops.
5. Connect the SST (NGS tester) to the DLC-2 and select the "PID/DATA MONITOR AND RECORD".
6. Select the "RPM" on the NGS display.
Ignition Timing
1. Perform "Preparation" above.
2. Verify that the idle speed is within the specification.
Specification: 600 - 700 (650 ± 50) rpm
^
If not as specified, adjust the idle speed.
3. Short the DLC terminal TEN to body ground using SST.
1. Connect the SST (system selector) to the DLC.
2. Set switch A to position 1.
3. Set the test switch to SELF TEST
4. Verify that the idle speed is within the specification.
Specification: 550 - 750 rpm
^
If not as specified, adjust the idle speed. (see below)