MPV L4-2606cc 2.6L SOHC (1989)
Throttle Sensor Adjustment
10. If not as specified, loosen the throttle sensor mounting screws and adjust BLUE wire voltage by rotating the throttle sensor. After adjusting the
voltage, tighten the throttle sensor mounting screws and recheck the voltage.
Throttle Valve Fully Open
11. Hold the throttle valve fully open.
12. Check that Blue and RED wire voltages. Check that the BLUE voltage corresponds with the RED voltage listed in the table below.
RED VOLTAGE (VOLTS)
BLUE VOLTAGE (VOLTS)
4.50-4.59
3.58-4.23
4.60-4.69
3.66-4.32
4.70-4.79
3.74-4.41
4.80-4.89
3.82-4.51
4.90-4.99
3.90-4.60
5.00-5.09
3.97-4.70
5.10-5.19
4.05-4.79
5.20-5.29
4.13-4.88
5.30-5.39
4.21-4.98
5.40-5.49
4.29-5.07
5.50
4.29-5.17
13. If not as specified, replace the throttle sensor.
14. Turn the ignition switch off.
15. Disconnect the Self Tester and reconnect the throttle sensor connector.
16. Disconnect the negative battery terminal and depress the brake pedal for at least 5 seconds to eliminate the control unit malfunction memory
created during inspection.