MPV DX V6-2.5L DOHC (2000)
8.
Confirm rear sliding door and power window operates properly.
9.
Disconnect negative battery cable again.
10.
Reinstall seat belt retractor.
11.
Reinstall B-pillar lower trim components in reverse order of Step 2.
12.
Repeat Steps 1-11 on other side B-pillar.
REAR DOOR - REAR SLIDING DOOR CONTACTS REPLACEMENT
1.
Remove door trim from rear sliding door according to the Workshop Manual (Section 09-17 SLIDING DOOR TRIM
REMOVAL/INSTALLATION).
2.
Completely remove inner moisture screen from rear sliding door (do not cut screen).
NOTE:
Refer to March/April 2005 M-Tips Newsletter for "Butyl Adhesive Handling Tip".
3.
Remove rear sliding door contacts from rear sliding door.
4.
Replace with modified rear sliding door contacts.
NOTE:
Be sure to install contacts with "UP" arrow pointing upward.
5.
Disconnect cables from clips ("00-01" MPV = 2 clips, "02-06" MPV = 4 clips) on rear sliding door.
6.
Remove grey urethane pad from upper door harness (remove as much material as possible).