MPV DX V6-2.5L DOHC (2000)
1. Remove the lower bearing using the Special Service Tool (SST) and a hammer.
NEEDLE BEARING DISASSEMBLY NOTE
1. Remove the needle bearing using the SSTs.
MOUNTING BUSHING DISASSEMBLY NOTE
1. Press out the mounting bushing from the gear housing using the SSTs and a press.
RACK INSPECTION
1. Inspect the rack for cracking, damage, and tooth wear.
^
Replace it as necessary.
2. Measure the runout of the rack.
^
If not within the specification, replace the rack.
Runout
Near point A: 0.15 mm (0.006 inch) max.
Near point B: 0.20 mm (0.008 inch) max.