MPV DX V6-2.5L DOHC (2000)
1. Use an awl to saw through the sealant, except where there are pins, fasteners, and spacers, from the inside of the vehicle.
WARNING: Using a SST (piano wire) with bare hands can cause injury. Always wear gloves when using a SST (piano wire).
2. Pass the SST (piano wire) through the hole.
3. Wind each end of the wire around a bar.
NOTE: Use a long sawing action to spread the work over the whole length of the SST (piano wire) to prevent it from breaking.
4. Working with another person, saw through the sealant around the edge of the glass, being careful not to damage the body.
5. Remove the rear window glass.
6. Remove the pins, spacers, and fasteners.
7. Remove the rear window molding from the rear window glass.
INSTALLATION
WARNING: Using a razor with bare hands can cause injury. Always wear gloves when using a razor.
CAUTION: To prevent the sealant from cracking or the glass from being pushed Out by air pressure it a door is closed, open all of the windows and
leave them open until the sealant has hardened.