MPV ES V6-2.5L DOHC (2001)
Sliding Door Interior Trim Panel: Service and Repair
REMOVAL/INSTALLATION
1. Disconnect the negative battery cable if equipped with power window.
2. Remove the sliding door garnish.
3. Remove the sliding door upper frame.
4. Remove the sliding door inner handle.
5. Remove the regulator handle if equipped.
6. Disengage clips A using a fastener remover.
7. Pull the sliding door trim upward, then disengage hook B from the body.
8. Disconnect the power window sub switch connector if equipped.
9. Remove the sliding door trim.
10. Install in the reverse order of removal.