MPV ES V6-2.5L DOHC (2001)
6. Remove the pins, spacers, and fasteners.
7. Remove the rear window molding from the rear window glass.
REAR WINDOW GLASS INSTALLATION
WARNING: Using a razor with bare hands can cause injury. Always wear gloves when using a razor.
CAUTION: To prevent the sealant from cracking or the glass from being pushed out by air pressure if a door is closed, open all of the windows and
leave them open until the sealant has hardened.
1. Cut away the old sealant using a razor so that 1 - 2 mm {0.04 - 0.07 in} thickness of sealant remains around the circumference of the frame.
-
If all the sealant has come off in any one place, apply some primer after degreasing, and allow it 30 minutes to dry. Then put on new sealant to
create a 2 mm {0.08 in} layer.
2. Clean and degrease an approximately 50.0 mm {1.97 in} wide strip around the circumference of the glass and the bonding area on the body.
3. Clean and degrease the ceramic parting of the glass and the bonding area on the body.
4. Fit the molding at lower corners. (1)
5. Install the molding at lower side. (2)