MPV ES V6-2.5L DOHC (2001)
Air Bag Control Module: Service and Repair
Deployment Authorization Procedure
AIR BAG MODULE DEPLOYMENT AUTHORIZATION PROCEDURE
NOTE: When replacing both the SAS control module and side air bag sensor together, perform only "After Replacing SAS Control Module"
After Replacing SAS Control Module
1. Install a new SAS control module.
1. Turn the ignition switch to ON position.
2. Verify that the air bag system warning light illuminates for approximately 6 seconds, goes off, and then flashes continuously.
-
If the air bag system warning light does not flash continuously and indicates a DTC, inspect the system using the on-board diagnostic
function. (See FOREWORD.) When the malfunctions have been repaired and the air bag system warning light flashes continuously, turn
the ignition switch to LOCK position. Wait for approximately 1 second or more and then turn the ignition switch back to ON position.
-
If the air bag system warning light flashes continuously, turn the ignition switch to LOCK position. Wait for approximately 1 second or
more and then turn the ignition switch back to ON position.
2. Verify that the air bag system warning light illuminates for approximately 6 seconds and then goes off.
-
If the light stays on, perform the deployment authorization procedure again.
After Replacing Side Air Bag Sensor
1. Install a new side air bag sensor.
2. Turn the ignition switch to ON position.
3. Verify that the air bag system warning light illuminates for approximately 6 seconds and then goes off.
-
If the light stays on, perform the deployment authorization procedure again.