MPV ES V6-2.5L DOHC (2001)
2. After installation, measure the outer diameter. If it exceeds the specification, repeat steps 1-2 using a new clip.
Outer diameter specification 30.9 mm (1.21 inch)
Joint Shaft Installation Note
1. Secure the shaft portion of the drive shaft in a vise.
2. Install the joint shaft using a plastic hammer as shown.
Wheel Hub, Steering Knuckle, Drive Shaft and Joint Shaft Installation Note
1. Install the joint shaft with the end-gap of a new clip facing upward.
Caution:
-
The sharp edges of the joint shaft can slice or puncture the oil seal. Be careful when installing the joint shaft to the transaxle.
Disassembly
JOINT SHAFT DISASSEMBLY
1. Disassemble in the order indicated in the table.
Joint Shaft Disassembly Note