MPV ES 2WD V6-3.0L SOHC (1998)
Evaporator Case: Service and Repair
Front Cooling Unit
Disassembly and Assembly
1. Remove the front cooling unit.
CAUTION:
-
If moisture or foreign material enters the refrigeration cycle, cooling ability will be lowered and abnormal noise will occur. Always
immediately plug all open fittings after removing any refrigeration cycle parts to keep moisture or foreign material out of the cycle.
-
To prevent the pipe from breaking, loosen the joint by using two open-end wrenches.
2. Disassemble in the order indicated in the table.
CAUTION:
-
To prevent the pipe from breaking, tighten the joint by using an open-end wrench and a torque wrench.
-
To prevent the O-ring from breaking, tighten the nut of the joint by hand.
3. Assemble in the reverse order of disassembly indicated in the table.
4. Install the front cooling unit.
Front Evaporator Assembly Note
-
When installing a new front evaporator, add ND-OIL8 compressor oil into the refrigeration cycle.
Supplemental amount
40 ml (40 cc, 1.4 fl.oz)