MPV ES 2WD V6-3.0L SOHC (1998)
2. Remove the nuts.
Propeller Shaft Removal Note
1. Push a rag into the double-offset joint to hold the propeller shaft straight and to prevent damage to the boot.
2. When the propeller shaft is removed from the extension housing, immediately install the SST into the extension housing to prevent oil leakage.
Propeller Shaft Installation Note
1. Push a rag into the double-offset joint to prevent damage to the boot.
NOTE:
-
New propeller shafts are equipped with an insulator to prevent damage to the boot.
2. Align the marks and install the propeller shaft.
Tightening torque 50-58 Nm (5.0-6.0 kgf-m, 37-43 ft. lbs.)