MPV LX V6-2.5L DOHC (2000)
Stabilizer Bushing: Technical Service Bulletins
Suspension - Revised Sway Bar Bushing Replacement
TSB: 02-005/06
2000 - 2006 MPV
REVISED FRONT STABILIZER BUSHING REPLACEMENT
PROCEDURE AND REPAIR TIME
APPLICABLE MODEL(S)/VINS
2000 - 2006 MPV
DESCRIPTION
This Service Bulletin is to inform all dealer Technicians of a revised procedure for sway bar bushing replacement. When sway bar bushing replacement
is required for the repair, follow the "Revised Sway Bar Bushing Replacement Procedure" below. This repair procedure supersedes the current repair
procedure found in the 2000 - 2006 MPV workshop manuals.
REPAIR PROCEDURE
Revised Sway Bar Bushing Replacement Procedure
NOTE:
It is NOT necessary to remove the FRONT CROSSMEMBER to replace the stabilizer bushings.
1.
Safely raise vehicle on hoist.
2.
Remove both front wheels.
3.
Remove lower control link nut.
4.
Disconnect control link from front stabilizer (to remove tension from stabilizer bar).
5.
From under vehicle and through wheel well opening, remove both bolts holding stabilizer bracket.
6.
Remove bracket and bushing.
