MPV LX V6-2.5L DOHC (2000)
Note Use the specified grease supplied in the boot kit.
1. Fill the outer ring and boot (transaxle side) with the specified grease.
Grease amount
135 - 155 g (4.77 - 5.47 oz.)
2. Install the outer ring.
3. Set the drive shaft to the standard length.
4. Release any trapped air from the boots by carefully lifting up the small end of each boot with a cloth wrapped screwdriver.
5. Verify that the drive shaft length is within the standard.
BOOT BAND (TRANSAXLE SIDE) ASSEMBLY NOTE
Note
-
Always use new bands.
-
The band should be folded in the direction opposite to the forward revolving direction of the drive shaft.
1. Fold the band back and use pliers to pull it tight.
2. Lock the end of the band by bending the locking clips.
BOOT BAND (WHEEL SIDE) ASSEMBLY NOTE