MPV LX 4WD V6-3.0L SOHC (1997)
ALIGNING DECAL
4 Wheel Drive Models
1.
Lay the badge face down on a fiat surface.
2.
Slowly pull the release liner away at a 180 degree angle to expose all of the badge adhesive.
3.
Visually align the top edge of the notches located on either side of the tape and liner with the middle feature line on the rear door.
4.
Align the vertical edge of the premask with the rear door panel edge.
2 Wheel Drive Models
1.
Tear away the 4WD area along the perforated line and discard.
2.
Lay the badge face down on a fiat surface.
3.
Slowly pull the release liner away at a 180 degree angle to expose all of the badge adhesive.
4.
Visually align the top edge of the tape and liner with the middle feature line on the rear door.
5.
Align the vertical edge of the tape and liner with the rear door panel edge.
APPLYING DECAL
1.
Allow badge to contact vehicle only when appropriate alignment is achieved.
2.
Tack the badge to the vehicle surface using hand pressure.