MPV LX 4WD V6-3.0L SOHC (1997)
Control Arm: Service and Repair
REMOVAL / INSTALLATION
1. Jack up the front of the vehicle and support it on safety stands.
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the
harness if it is pulled out by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an
appropriate place where the sensor will not be pulled by mistake while servicing the vehicle.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal indicated in the table.