MPV LX 2WD V6-3.0L SOHC (1998)
2. Install the spring plate properly. When reinstalling, insert the spring plate over the valve bodies in the correct position to preload the spring and to
center the solenoid coils.
3. Carefully fit the coils of the ABS CM over the valve bodies.
4. Locate the ABS CM by placing the new bolts evenly against the housing and tightening them slightly by hands. To aid alignment, the housing may
be pressed onto the contact surface by hand while tightening the bolts.
5. Tighten the bolts to the specified torque in the order shown.
Tightening torque: 2.4 - 2.8 Nm (21 - 24 inch lbs.)
6. Visually inspect for all bolts mode contact. The ABS CM must be fixed against the housing with no gap in the area of the bolts.
7. Connect the 2-pin connector of the pump motor to the ABS CM. Verify that the spring clip is engaged securely.
8. Clip the wiring back in the cable guide.
9. Reinsert the soft mount if it is fallen out.
10. Inspect flats of two side retaining bolts and position flats vertically by turning bolts as necessary.