MPV LX 2WD V6-3.0L SOHC (1998)
Evaporator Case: Service and Repair
Rear Cooling Unit
Disassembly and Assembly
1. Remove the rear cooling unit.
CAUTION:
-
If moisture of foreign material enters the refrigeration cycle, cooling ability will below and abnormal noise will occur. Always immediately
plug all open fittings after removing any refrigeration cycle parts to keep moisture or foreign material out of the cycle.
-
To prevent the pipe from breaking, loosen the joint by using two open-end wrenches.
2. Disassemble in the order indicated in the table.
CAUTION:
-
To prevent the pipe from breaking, tighten the joint by using an open-end wrench and a torque wrench.
-
To prevent the O-ring from breaking, tighten the nut of the joint by hand.
3. Assemble in the reverse order of disassembly indicated in the table.
4. Install the rear cooling unit.
Rear Evaporator Assembly Note
-
When installing a new rear evaporator, add ND-OIL8 compressor oil into the refrigeration cycle.
Supplemental amount 40 ml (40 cc, 1.4 fl.oz)
Rear Expansion Valve Assembly Note
1. Apply A/C compressor oil to the O-rings and connect the joints.
2. Assemble the heat-sensing tube as shown in the figure.