MPV LX 2WD V6-3.0L SOHC (1998)
Suspension Spring ( Coil / Leaf ): Service and Repair
Front Suspension
Part 1 Of 2
Part 2 Of 2
FRONT REMOVAL / INSTALLATION
1. Jack up the front of the vehicle and support it on safety stands.
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the
harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an
appropriate place where the sensor will not be pulled by mistake while servicing the vehicle.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal indicated in the table.
4. Inspect the front wheel alignment and adjust it if necessary.
Piston Rod Nut Removal Note
WARNING: Removing the piston-rod nut is dangerous. The shock absorber and spring could fly off under tremendous pressure and
cause serious injury or death. Secure the shock absorber in the Special Service Tool (SST) before removing the piston-rod nut.
1. Secure the mounting block in a vise.