MPV LX 2WD V6-3.0L SOHC (1998)
-
Install the center bearing support component onto the front propeller shaft by using the SSTs.
Flange Nut Assembly Note
1. Align the marks on the flange and shaft.
2. Install the lock washer and temporarily tighten the flange nut.
3. Place the center companion flange in a vise.
4. Tighten the flange nut to the specified torque.
Tightening torque 157-176 Nm (16-18 kgf-m, 116-130 ft. lbs.)
Rear Propeller Shaft Assembly Note
1. Push a rag into the double-offset joint to prevent damage to the boot.