MX-3 L4-1598cc 1.6L DOHC (1995)
View: Special Service Tool (SST)-Sheet Overlay
3. Place the SST engine signal sheet overlay on the SST engine signal monitor.
4. Turn ignition switch ON.
5. Measure voltage at ECM terminal 1V.
Park or Neutral gear range:--0.0 Volts.
Other gear ranges:--Battery Positive Voltage.
6. If signal is not as specified check the following:
-
Transaxle range switch, wiring between switch and transaxle control module (TCM). TCM input terminal (from P/N switch) is 2B.
-
Wiring between TCM output terminal 1D to ECM input terminal 1V.
7. Repair or replace failed components/wiring as necessary.
