MX-5 Miata L4-1.8L DOHC (1996)
Radiator Cooling Fan Motor Relay: Testing and Inspection
Procedures With Tester
COOLING FAN
-
Verify that the engine is cold.
-
Turn the ignition switch to ON.
-
Verify that the cooling fan is not operating.
-
If the cooling fan is operating, do as follows:
-
Connect the SSTs (NGS) to the data link connector-2.
-
Select the PID/DATA MONITOR AND RECORD function on the NGS display.
-
By using the "FANC" and verify that the cooling fan control signal is OFF.
-
If the cooling fan control signal is ON, check the following:
- ECM terminal voltage
- Engine coolant temperature signal
-
If the cooling fan control signal is OFF, check the following:
- Cooling fan relay
- Short circuit in wiring harnesses and connectors (Main relay - Cooling fan relay - ECM)
-
Connect the SST (System Selector) to the data link connector.
-
Set switch A to position 1.
-
Set the test switch to SELF TEST.
-
Depress the accelerator pedal and verify that the cooling fan operates.
-
If the cooling fan does not operate, do as follows:
-
Connect the SSTs (NGS) to the data link connector-2.
-
Select the SIMULATION TEST function on the NGS display.
-
Turn the cooling fan relay from OFF to ON by using the "FANC" and check for the cooling fan operation.
-
If the cooling fan operates, check the following:
- ECM terminal voltage
- Test mode signal
- Closed throttle position signal
-
If the cooling fan does not operate, do as follows:
- Turn the cooling fan relay from OFF to ON by using the simulation function. Operate the cooling fan relay and check it the operation
sound of the relay is heard.
- If the operation sound is heard, check the following:
- Wiring harnesses and connectors (Cooling fan relay - Cooling fan motor)
- Cooling fan motor
- If the operation sound is not heard, check the following:
- Cooling fan relay
- Open circuit in wiring harnesses and connectors (Main relay - Cooling fan relay - ECM)
CONDENSER FAN RELAY
-
Verify that engine is cold and the A/C switch and blower switch are OFF.