mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Convertible Top Cover - Flapping at High Speeds|Page 4584 > < Soft Top Boot - Flaps At High Speed|Page 4579
Page 1
background image

Convertible Top: All Technical Service Bulletins
Convertible Top Cover - Flapping at High Speeds

Bulletin No.: 034/96
Issued: 07/12/96
Revised

Category

S

Applicable Model/s
All MX-5 Miata

Subject:
CONVERTIBLE TOP COVER FLAPPING WHILE DRIVING

APPLICABLE MODELS/VINS
All MX-5 Miata with a VIN of JM1NA35**S0614106 to JM1NA35**T*704232

DESCRIPTION

The top cover may flap while driving at high speeds [+50 mph (+80 km/h)] with the convertible top down and the top cover installed. This flapping is
caused when the front buttons on the cover become disconnected, allowing air to circulate under the cover.

To eliminate the flapping, cover straps are incorporated into production. Customers complaining of this concern should have the straps installed
according to this bulletin.

REPAIR PROCEDURE

1.

Remove the cover from the vehicle.

2.

Bore two (2) holes in the cover 2 - 3 mm in diameter, 20 mm from the cover notch and 5 - 6 mm from the cover edge.

3.

Repeat step 2 on the opposite side.

Convertible Top Cover - Flapping at High Speeds|Page 4584 > < Soft Top Boot - Flaps At High Speed|Page 4579