MX-5 Miata L4-2.0L (2008)
-
When connecting the negative battery cable to the battery, connect the negative battery cable and the ground cable as shown in the figure.
Wiring Harness
-
To remove the wiring harness from the clip in the engine room, pry up the hook of the clip using a flathead screwdriver.
Caution
-
Do not remove the Harness protective tape. Otherwise, the wires could rub against the body, which could result in water penetration
and electrical shorting.
CONNECTORS
Data Link Connector
-
Insert the probe into the terminal when connecting a jumper wire to the data link connector.
Caution
-
Inserting a jumper wire probe into the data link connector terminal may damage the terminal.
Disconnecting Connectors