MX-5 Miata LS L4-1.8L DOHC (2001)
Throttle Position Sensor: Testing and Inspection
NOTE:
-
The TP sensor on this type of vehicle is maintenance-free.
-
Perform the following test only when directed.
1. Measure the PID value.
-
If PID value is not as specified, inspect as follows:
-
Verify that the throttle valve is fully closed.
-
Accelerator cable free play
-
Throttle cable free play
-
If the above are okay, but PID value is out of specification, perform the "Circuit Open/Short Inspection".
2. Reconnect the TP sensor connector.
-
If the above open or short circuit are correct, replace TP sensor.
Circuit Open/Short Inspection
Open circuit
-
If there is no continuity, the circuit is open. Repair or replace the harness.
-
Reference voltage circuit (TP sensor connector terminal A and PCM connector terminal 4L.)
-
TP circuit (TP sensor connector terminal C and PCM connector terminal 4V.)
-
GND circuit (TP sensor connector terminal B and PCM connector terminal 4O.)
Short circuit
-
If there is continuity, the circuit is shorted. Repair or replace the harness.
-
TP sensor connector terminal A and PCM connector terminal 4L to GND.
-
TP sensor connector terminal C and PCM connector terminal 4O to GND.