MX-5 Miata LS L4-1.8L DOHC (2001)
Transmission Speed Sensor: Service and Repair
Output
OUTPUT SPEED SENSOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Disconnect the output speed sensor connector.
3. Remove the output speed sensor from the transmission.
4. Apply ATF to a new O-ring.
5. Install the O-ring to the output speed sensor.
6. Install the output speed sensor to the transmission.
Tightening torque 5.0 - 6.8 Nm (50 - 70 kgf-cm, 44 - 60 inch lbs.)
7. Connect the output speed sensor connector.
8. Connect the negative battery cable.