MX-5 Miata Mazdaspeed L4-1.8L DOHC Turbo (2004)
Oxygen Sensor: Technical Service Bulletins
Engine Controls - O2 Sensor Removal Precautions
Bulletin No: 01-032/10
Last Issued: 05/27/2010
Subject:
OXYGEN / AIR FUEL RATIO SENSOR REMOVAL CAUTION
*BULLETIN NOTE
^
This bulletin supersedes the previous bulletins 01-019/07 issued 05/10/07, 01-006/08 issued 02/11/08 and 10/10/08, 01-051/09 issued 11/19/09.
^
Changes are noted by asterisks.*
APPLICABLE MODEL(S)/VINS
1997-2003 Protege
1997-2005 Miata
1997-2002 626
1997-2002 Millenia
1997-2006 MPV
2001-2006 Tribute
2008-2010 Tribute
2008-2010 Tribute Hybrid
2003-2010 Mazda6
2004-2010 Mazda3
2004-2010 RX-8
2006-2010 Mazda5
2006-2010 MX-5
2007-2010 CX-7
2007-2010 CX-9
DESCRIPTION
Use the following repair procedure to minimize the need to replace the catalyst converter/exhaust pipe when removing oxygen sensors and/or air fuel
ratio sensors.
REPAIR PROCEDURE
Oxygen Sensor Removal Procedure
WARNING:
To avoid personal injury, allow exhaust system to cool down before removing oxygen sensor.
NOTE:
In some cases oxygen sensor and/or air fuel ratio sensor seizure will occur during this removal procedure. If seizure occurs, remove the converter or
exhaust pipe from the vehicle and re-attempt removal with the assembly placed in a vise. This will maximize your positioning and ability to apply
adequate torque to remove the sensor.
1. If reusing oxygen sensor, mask it with masking tape to prevent lubrication soaking.